The Telemetry Radio Set V3 is based on the JST-GH plug system and is therefore convenient for the usage with flight controller such as the Pixhawk 4. If the Set is used with older flight controllers there is a cable given by that enables the connection with these systems and the Telemetry Radio Set V3. The automatic detection of ArduPilot and Dronecode enables an easy and comfortable start-up of the Set.
Connecting & Implementing
The Telemetry Radio Set V3 can used with a hugh variety of flight controllers and can also be used with both Android devices and computers. If a Pixhawk 4 controller is used one part of the telemetry set has to be attached to the bus that is labeled with "Telem 1". To connect the second component of the Radio Set with an computer or an Androird device the Radio Set has to be connected to a free USB Port, the required cable is part of the Radio Set. The communication between the computer/Android device is realized with the already integrated FTDI Chip, but in some cases it may be required to install an external FTDI driver.
Technical data
- Power transmission: 0 - 100mW / 500mW (depending on the version)
- Firmware: OpenSource SIK
- Error tolerance: adjusts up to 25% of an incorrect signal (Software)
- Configuration: Mission Planner & APM Planner
- Interface: Integrated USB (FT230X)
- UART Interface: 3,3V
- Dimensions: 26 x 53 x 10,7mm (without Antenna)
- Transmitter power: 100mA
- Reciever power: 25mA
Scope of delivery
- 2 x Radio Module incl. Antenna
- 1 x Micro USB Cable
- 1 x Android OTG Cable
- 1 x GH 6P-GH 4P Cable
- 1 x MLW 6P-GH 4P Cable
- 2 x SMA Adapter
Shipping weight: | 0,12 Kg |
Product weight: | 0,10 Kg |