Telemetry Radio Set V3 433MHz 100mW

SKU: MBS-Z-34-001
GTIN: 0089336484258
Category: Accesoires
Manufacturers:

Telemetry Radio Set V3

433MHz
> 300m Range
Automatic detection with ArduPilo & DroneCode
easy start-up with Pixhawk 4

Please note that without the appropriate radio operator license, the transmission power must be throttled to 25mW.

Transceiver Power

119,95 €

incl. 19% VAT , plus

Available immediately
Delivery time: 1 - 4 Workdays (DE - int. shipments may differ)

The Telemetry Radio Set V3 is based on the JST-GH plug system and is therefore convenient for the usage with flight controller such as the Pixhawk 4. If the set is used with older flight controller there is a cable given by that enables the connection with these systems and the Telemetry Radio Set V3.. The automatic detection of ArduPilot and Dronecode enables an easy and comfortable start-up of the Set.

Connecting & Implementing

The Telemetry Radio Set V3 can be used with a hugh variety of flight controllers and can also be used with both android devices and computers. If a Pixhawk 4 controller is used one part of the telemetry set has to be attached to the bus that is labeled with "Telem 1". To connect the second component of the Radio Set with an computer or an Android device the Radio Set has to be connected to a free USB port, the required cable is part of the Radio Set. The communication between the computer/Android device is realized with the already integrated FTDI Chip, but in some cases it may be required to install an external FTDI driver.

Technical data

Power transmission: 0 - 100mW
Firmware: OpenSource SIK
Error tolerance: adjusts up to 25% of an incorrect signal (Software)
Configuration: Mission Planner & APM Planner
Interfacee: Integrated USB (FT230X)
UART Interface: 3,3V
Dimensions: 26 x 53 x 10,7mm (Ohne Antenne)
Transmission power: 100mA
Reciever power: 25mA